Install and Test Assembled UIRT2



The UIRT2 is now ready for installation and use.

Power down PC and remove the power plug.

Remove the cover and locate an empty card slot.

Connect the WOL wire between the WOL connection on the motherboard and the UIRT2. If an alternative +5V supply is used, connect as required.

Install the board into the open slot then securely screw the bracket in place.

Plug in the receiver and emitter plugs into their proper jacks.

Connect the UIRT2 to the PC using the serial cable.

Replace cover and power-up the PC.



A test program written by Anders should be installed and run to ensure the UIRT2 is operating correctly.  

Download  here